AJ72LP25G | MITSUBISHI Coaxial cable module AJ72LP25G

Program memory capacity 14K.
Input and output points to the maximum 512 points.
A scan cycle of PLC must pass through three stages: input sampling, program execution and output refresh.
PLC in the input sampling phase: first of all, in order to scan the sequence of all existing input latches in the input terminal of the state or input data read,
And write it into the coorresponding input status register,
Refresh the input, then close the input port, enter the program execution stage AJ72LP25G. Bus connection AJ72LP25G.
Program 2 channel connection.
MITSUBISHI PLC detection, fault diagnosis and display and other procedures.
These procedures are relatively independent, generally in the basic completion of the program design and then add MITSUBISHI AJ72LP25G.
MITSUBISHI PLC protection and chain procedures AJ72LP25G.
Protection and chain is an indispensable part of the program, must be carefully considered.
It can avoid the control logic confusion caused by illegal operations. Self service (IN, OUT): SI optical cable MITSUBISHI AJ72LP25G.
Other aspects (IN, OUT): SI optical cable.
Data link anomaly Bureau bypass.
Inter agency extension.
Cable transformation. Adapter for mounting rails. Unit connection CPU unit.Input type: DC input, positive common end.
Input points: 8 points.
Enter the response time: 1 MITSUBISHI AJ72LP25G.5ms the following.
Rated input voltage / current: DC24V/5mA.
Output form: transistor output, leakage type.
Output points: 8 points.
OFF leakage current: 0.1mA.
Output protection function: No.
Rated load voltage / current: DC24V/0.5A.
External connection: 4 wire.
Fast connector type.
Simple wiring through quick connector.
Can be installed along the 6 direction.
MITSUBISHI PLC program simulation debugging
The basic idea of program simulation debugging is,
In order to facilitate the form of simulation to generate the actual statee of the scene,
Create the necessary environmental conditions for the operation of the program AJ72LP25G.
Depending on the way the field signals are generated,
The simulation debugging has two forms of hardware simulation and software simulation.