Conditional data QD75M4 module in slot number 0, I-O 00-01F. advanced positioning
5M4 module in the slot number 0, using the condition data No. I/O 00-01F. advanced positioning (Y soft element ON), soft element Y in WORKS2 is Y00-Y1F, but the Y00-Y1F is occupied by the QD75 module

TL-T5MY1 2M
5MY1 2M this model discontinued with what model to replace?

The E2 counter shows how E1 and E2 are
E2 counter shows how E1 and E2 are

Can the QD75M2 bring only 1 servo motors?
5M2 is a 2 axis module. Can you bring only 1 servo motors?

QD75MH4 and servo control
5MH4 and MR-J3B consist of 4 axis servo control system, a device set on the 2 axis as a group, were divided into two groups of X, Y axis control of the same work, if one group within the servo or exte

QD75MH4 module use
5MH4 module maintain its internal parameters? I didn't see the battery box on the module. 2. What are the ways to save the part of the module parameters? 3. In general, how are the parameters of QD7

TXD sends ASCII Code: N Q65MM, 10MM B-CJ1W-NC482
5MM, 10MM? B20120,0, K, 3,5,61, B, "A01234D"? P1? Does the program write this right? MOV #0200 D1100 MOV #4E0D D1000 MOV #0A51 D1001 MOV #3635 D1002 MOV #4D4D D1003 MOV #4D0D D1006 MOV