MR-J3-10A servo question?
Hello. I do a project, an ordinary motor rotation, speed is about 700 rpm, an ordinary motor with an encoder to detect the rotation angle, corresponding to the signal to control another servo motor.

MR-J3-20A origin search problem
Now encountered a problem, that is, in the implementation of the servo origin search, hit the DOG signal can not capture the Z phase signal (open collector OP 33 pin), which led to the servo motor can

Consult the MR-J3-A servo problem?
Hello.. I do a project, an ordinary motor does not stop rotating, the speed is about 700 rpm, an ordinary machine with an encoder to detect rotation angle, corresponding to the signal to control anot

Is MITSUBISHI servo MR-J3-20A not too supportive for windows7?
MITSUBISHI servo MR-J3 on windows7 is not too support, and now can not connect with SETUP221E, and PLC programming software can be used. I wonder if anyone mentioned this problem

MR-J3-40A servo format
With communication RS485 communication, modify the PA09 parameter for 21, station number is 1H, how to write it?？