MITSUBISHI GT10-20PSGB User's Manual PDF

Cable length: 3m.
The connection between the FXCPU communication function extension board (D-SUB9 pin connector) and the GOT/ personal computer (D-SUB9) (GTSoftGOT100 pin) GT10-20PSGB PDF.
The connection between the FXCPU communication function adapter (D-SUB9 pin connector) and the GOT.
For personal computer (screen design software) (D-SUB9 pin, the mother''s head) and GOT (D-SUB9 needle, the mother of the head) of the connection between GT10-20PSGB
Applicable models: GT16, GT15, GT11, HandyGOT, GT10, GT27, GT25, GT23,, GT21. Protective film for 5.7 inch screen.
Scrub, 5.
Applicable model: GT14. Cable length: 0.7m.
For the connection between QnAS/AnSCPU/ motion controller A7GT-CNB (A Series) and CPU GT10-20PSGB PDF.
Applicable models: GT16, GT15, GT11. Protective film for 4.5 inch screen.
Transparent, 5.
Applicable model: GT1030. Cable length: 20m.
For the connection between the two graphic operations.
Applicable models: GT16, GT15, GT11 GT10-20PSGB PDF. For video input (NTCS/PAL) 1 channel motion picture playback.
Applicable model: GT16. Series: multimedia and advanced features and features of a variety of high-performance models.
Screen size: 8.4 inches.
Display color: 256 color or more color.
Installation type: compatible with multimedia and video /RGB MITSUBISHI User's Manual.
Resolution: SVGA (800 x 600).
Display device: TFT color (high brightness, wide viewing angle).
Host frame color: black.
Power type: AC100~240V.
Communication interface: with built-in RS-422.
High performance models with multimedia and advanced features and functionality (including embedded communications capabilities) MITSUBISHI User's Manuual GT10-20PSGB Manual .
User storage capacity: 15MB (GT16__-VNB__:11MB).
With HOST USB and device USB port.
Standard Ethernet, RS-422/485 and RS-232 ports.
Support multimedia and video /RGB units.
Analog touch panel.
Do not let the touch screen surface with water drops or other soft things stick to the surface,
Otherwise, the touch screen is easy to mistake that there is a hand touch caused by surface acoustic wave screen is not allowed MITSUBISHI User's Manual.
In addition to cleaning the dirt on the surface of the touch screen,
You can use a soft dry cloth or a cleaning agent to clean out the center of the screen carefully,
Or use a dry soft cloth dipped in industrial alcohol or glass cleaning fluid to clean the touch screen surface.
Touch screen response is slow if you use a hand or other touch to touch the surface acoustic wave touch screen,
This shows that it is likely that the touch screen system has been obsolete, the internal clock frequency is too low,
Or because there is water in the surface of the touch screen to make the touch screen mobile, rapid response recovery,
To replace or upgrade the system must, or usee dry cloth touch screen on the surface of the water GT10-20PSGB User's Manual.
If the user is operating the touch screen, the direction of the touch move is to the left,
But the cursor of the system moves to the right,
The failure may be due to the conneection of the control box and the touch screen connected to the connector or the touch screen,
Users as long as the direction of the re exchange of it GT10-20PSGB Manual .