MITSUBISHI LD77MS4 User's Manual (Positioning control) PDF

Output points: 16 points.
Output form: source type.
Rated output voltage: DC12 ~ 24V.
Max load current: 0.5A/1 point.
Protection function: have.
Common way: 16 point / public end LD77MS4 PDF.
Input / output occupied points: 16 points (I/O distribution: output 16 points).
External wiring connection: 18 point terminal.
The switch input and output module is a device which can collect the input / output of the switch signal,
Digital I/O modules are often called LD77MS4
The switch signal is collected to the computer or the computer to send the relevant instructions through the RS-485 bus to control the switch of the switch,
Can also be carried out through the RS-485 bus communication,
Remote control switch LD77MS4 PDF.
Communication protocol is a standard Modbus protocol or custom protocol. Slim type non isolated.
Input power: DC24V.
Output: DC5V, 5A.
Power supply module can be directly pasted on the printed circuit board of the power supply,
Thee device is characterized in that a special integrated circuit (ASIC), a digital signal processor (DSP), a microprocessor, a memory, a field programmable gate array (FPGA), and other digital or analog loads are provided LD77MS4 PDF LD77MS4 Manual .
In general, this type of module is called the load point (POL) power supply system or the use of point power supply system (PUPS) MITSUBISHI User's Manual.
Because of the advantages of the modular structure,
The module power supply is widely used in switching devices, access devices, mobile communications, microwave communications and optical transmission, routers and other communication fields and automotive electronics, aerospace, etc MITSUBISHI User's Manual. . "Output points: 32 points.
Output type: leakage type.
Rated output voltage: DC12 ~ 24V.
Max load current: 0.1A/1 point.
Protection function: have.
Common way: 32 point / public end.
Input / output occupied points: 32 points (I/O distribution: output 32 points) MITSUBISHI User's Manual.
External wiring connection mode: 40 pin connector.
The switch input and output module is a device which can collect the input // output of the switch signal,
Digital I/O modules are often called LD77MS4 User's Manual.
The switch signal is collected to the computer or the computer to send the relevant instructions through the RS-485 bus to control the switch of the switch,
Can alsso be carried out through the RS-485 bus communication,
Remote control switch LD77MS4 Manual .
Communication protocol is a standard Modbus protocol or custom protocol.