MITSUBISHI QD75MH2 User's Manual (Details) PDF

8 channels.
Input: AC0~5A AC0~50A, CT, AC0~100 until AC0~600A.
Output: 0~10000.
18 point terminal.
Directly connected to the CT sensor, saving wiring and space of the CT input module QD75MH2 PDF.
Directly connected with CT sensor and programmable controller,
No need for external connection signal converter, etc..
Very accurate measurement results can be obtained by stable data transfer speed,
Then, load control and operation of the system and equipment are carried out, and the power supply system is managed and monitored QD75MH2
Directly connect the CT sensor, saving wiring and space
In the case of no external signal converter, directly connected to the CT sensor QD75MH2 PDF.
A module can be used to measure up to 8 channels of aalternating current, thereby reducing wiring time and cost QD75MH2 Manual.
Set the CT sensor type (input range) for each channel.
Through a module to select from AC0 ~ 5A to 600A ~ CT AC0 sensor.
Preventive maintenance can be carried out by detecting the peak current QD75MH2 PDF.
Peak current detection function
By detecting the peak current, the equipment can perform maintenance and troubleshooting.
Take the motor as an example, the load applied on the motor changes due to wear and damage of the gear,
Load current will suddenly change MITSUBISHI User's Manual.
By detecting the transient peak current at this time, the fault of the equipment can be diagnosed.
Input signal error detection function
Can detect whether the CT input value is out of range (higher than the peak value).
Because the large current flow on the measurement object is beyond the range limit,
Therefore, the error of the measurement object can be monitored MITSUBISHI User's Manual. Cable length 1.2 meters.
Extended substrate for connection.8 slots; requires 1 AnS series PLC power modules;
Used to install large AnS series PLC module.
Base plate of AnS series PLC QD75MH2 User's Manual.
QA1S series PLC 8 slot main substrate MITSUBISHI User's Manual.
AnS series of modules can be installed. Bidirectional thyristor output: 32 points.
Rated current and voltage: 240V ~ 0.6A/1 AC100 point, 2.4A/1 public eend, 8 point 1 Public end QD75MH2 Manual.
Response time: 1ms+0.5 cycle.
External wiring connections: 38 terminals (terminals sold separately).
Replacement model: AY23.