OMRON E5CC-CX0DSM-000 User's Manual PDF

Pressure range: Negative pressure; 0 to -101 kPa.
ON/OFF output: Open collector (two independent outputs).
Linear output: 1 to 5 V.
Model: NPN output E5CC-CX0DSM-000 PDF.
Pressure Sensor with.
Easy-to-Read LED Display.
Pressure status can be checked at a glance from the,
digital display and bar display.
Measurement pressure prevents incorrect outputs due,
to momentary pressure changes.
Perform automatic teaching simply by teaching pressure,
values for good and bad products E5CC-CX0DSM-000
Industry’s smallest models at just 28 × 28 × 29 mm.
Only in hysteresis mode. The ultra small size, high performance and rich models E5CC-CX0DSM-000 PDF.
5.5mm ultra small built-in amplifier.
Maximum detection distance 2.5mm. Workpiece shaking can also be stable detection.
Response frequency 1kHz.
Low consumption current.
Category: DC 2 wire type.
Shape: non shield.
Detection surface: above.
Detection range: 2.5mm.
Action mode: NO. E3JM-R4M4T detection method: Regression reflection type with M E5CC-CX0DSM-000 PDF. S.R. function,
Connection: terminal plate,
Detection range: 4m.
Output status: ON into the light; light shading ON; switch conversion type.
Output: relay. Function: timer,
2 types of cost reductionSensing method: Through-beam (Emitter + Receiver) OMRON User's Manual.
Connection method: Pre-wired (2 m).
Sensing distance: 300 mm.
Operation mode: Dark-ON.
Model: NPN output.
Makes Mounting and Installation Simpler and Smoother.
Suitable for Applications in the Rechargeable Battery Industry. Model: Shielded, M8.
Sensing distance: 1 OMRON User's Manual. 5 mm.
Output configuration: DC 3-wire, NPN.
Model: Operation mode, NO.
Proximity Sensor with Resin Case,
with Superb Water Resistance.
IP68 protection.
Mutual interference prevention with models with different,
frequencies is also available. E3JK-R12 regression reflection type,
E3JK direct current mode: mode; ON,
Miniature amplifier buillt-in type photoelectric switchSize: 96 x 96mm OMRON User's Manual E5CC-CX0DSM-000 Manual.
Control output 1: voltage output (SSR driver).
Control output 2: relay output.
Auxiliary output: 2 independent points.
Power supply voltage: AC/DC24V.
Terminal shape: screw terminal table type.
Input category: full range multi input.
Heating wire break, SSR fault detection function: 1 points.
Communication: RS-485.
Event input: 2 points.
Remote SP input: -.
Transfer output: -.
Large screen display white PV legible. From selection to setting and operation are simple and easy to use.
Full capacity, function and performance of I/O. Suitable for more applications.
E5AC white LCDPV display height is about 25mm.
The upper panel and the front panel are equipped with tool ports.
With the communication conversion line (sold separately) connected to the computer to establish the controller without the need to install the wire for power supply.
Easy to install CX-Thermo (sold separately).
50ms high speed sampling period.
Model can be equipped with up to 4 point auxiliary output, 6 point event input,
1 point transfer output and remotte SP input, suitable for a wide range of applications E5CC-CX0DSM-000 User's Manual.
The main body is short, the thickness is only 60mm.
Easy to use programmable logic controller (PLC) is connected to the programmable logic controller (PLC).
The temperrature controller is connected to each other by using the component communication E5CC-CX0DSM-000 Manual.
A new type of proportional control allows you to control the valve.