Max input / output points: 80 points.
Supply voltage: 100 - 240VAC.
Input points: 40 points.
Output points: 40 points.
Output type: relay.
Power consumption: 50W.
Size (WxHxD) mm:285x90x86.
Faster and more efficient. Support high speed control and network communication, and have the function of data recording MITSUBISHI FX2NC-ROM-CE1.
High speed, large capacity, multi-function high-end machine FX2NC-ROM-CE1
FX3U supports high speed processing, CC-Link communication, network communication, analog control and advanced positioning system.
Connected to the CC-Link, including the remote I/O, the maximum input and output control points up to 384 points,
Can correspond to a variety of field needs, the use of its scalability and flexibility to expand the scope of application of the control system MITSUBISHI FX2NC-ROM-CE1.
Third generation high function micro programmable controller.
High speed, high efficiency, high performance, large capacity, and new features.
Built in high speed processing and positioning.
Control points: maximum 256 points.
Use CC-Link remote I/O for 384 points. Max input / output points: 10 points.
Power supply voltage: DC24V MITSUBISHI FX2NC-ROM-CE1.
Input points: 6 points.
Output points: 4 points.
Output type: relay.
Power consumption (W): 19.
Size (WxHxD) mm:60x90x75.
Positioning and pulse output functions: a PLC cell can output 2 point 100KHz pulses at the same time FX2NC-ROM-CE1 MITSUBISHI.
PLC is equipped with 7 special positioning instructions,
Including zero return, absolute or relative address expression and special pulse output control FX2NC-ROM-CE1 MITSUBISHI.
Host has 10 points (6I/4O), 14 points (8I/6O), 20 points (12I/8O), 30 points (16I/14O) of 4 types.
This type of PLC is mainly used in all of the digital input, digital output control point of the device.
Can be directly connected to the 220V city power, built-in 8K step EEPROM memory, no battery, easy to maintain FX2NC-RROM-CE1 MITSUBISHI FX2NC-ROM-CE1.
The series transistor output (MT) of the PLC, can be output 2 100KHz pulse, direct drive servo or stepper motor.
The series PLC can not be brought with the expansion module, but can be installed by the BBD board to extend a small amount of I/O MITSUBISHI FX2NC-ROM-CE1.
The series 1N through the installation of BD series PLC board, can achieve RS232, RS485, RS422 communication.