LK166
Home >> Products >> OMRON >> Power/other peripheral devices >> Connection / Save wiring equipment >> I/O relay terminal >> G70D-SOC08 OMRON G70D-SOC08

G70D-SOC08 OMRON G70D-SOC08

Brand: OMRON
Name: Relay terminal
Model: G70D-SOC08
Category: relay output.
Points: 8 points (1a * 8).
Common line processing on the connector side: NPN correspondence (+ public).
Rated voltage: DC24V.
Achieve control cabinet miniaturization / save time,
Relay terminal for 8 point output.
Small size of 68 * high 80 * 44mm. (vertical installation)
Total wiring of connector cable.
The common end can be easily connected with the independent contact and the short circuit piece.
The G70D-SOC08 and G70R-SOC08 are connected by a short circuit chip.
When the relay does not need the tool, the relay is convenient to replace the work.
With terminal cover to prevent electric shock.
With action indication LED.
Diode for internal coil surge absorption.
DIN guide rail installation, screw mounting common.

Model: P7S/P7SA, pages 20 and 21, PCB terminals.
Approx: 10 g.
Number of pins: 14 pins.
A Wide Variety of Square and,
Round Sockets in Front-mounting,
and Back-mounting Models,
Models available with finger protection.
Hold-down Clips and Socket Bridges for PYF Sockets,
are also available.
New screwless models available OMRON G70D-SOC08. Time specification: Inverse type.
Current setting range: 50 to 160 A G70D-SOC08
Operating voltage: 200/220/240 VAC.
Resetting method: Automatic.
Solid-state Relay Enables Choice of Three.
Operating Functions (Overcurrent, Open,
phase, and Reverse-phase).
Protects 3-phase induction motors and their loads from damage.
Selection and combination of operating functions from overcur,
rent, open-phase, and reverse-phase OMRON G70D-SOC08.
Circuit and output relay operation can be checked by just operat,
ing the test button.
The set time value can be checked easily because operation time,
is indicated from the start of operation.
Space-saving, integrated construction.
Note: If the K2CM is used with an inverter, the operating conditions will,
depend on the load wiring length, inverter carrier frequency, basic,
frequency, and load conditions OMRON G70D-SOC08. Error will occur in the operating,
values of the overload elements. It is recommended to test operation, Cable specifications: Fire-retardant, Robot cable.
Cable length L: 3 m.
Cable outer diameter: 6 mm.
Straight Connectors.
Minimum order: 5.
UL: Yes.
Round Water-resistive Smartclick.
Connectors That Reduce Installation Work.
A newly developed lock mechanism that is compatible with round M12 connectors.
Simply insert the Connectors, then turn them approximately 1/8 of a turn to lock.
A positive click indicates locking.
Features the same degree of protection (IP67) as M12 connectors.
A full linne-up of models is planned G70D-SOC08.
Connectors with Cables are UL approved. Model: PY (back-mounting), page 15, Solder terminals.
Number of pins: 8 pins.
A Wide Variety of Square and,
Round Sockets in Front-mounting,
and Back-mounting Modelss,
Models available with finger protection G70D-SOC08.
Hold-down Clips and Socket Bridges for PYF Sockets,
are also available.
New screwless models available.


...More relevant models >>>>