Pulse nUMber error relative to pulse output
If the relative pulse output through the SFT instruction to complete the action can see the action of the motor to one side, if every time when there is a delay of output pulse will not appear bias pr

Yaskawa servo motor model SGM-04A3G16B nUMbers and letters represent what meaning
UMbers and letters represent what <br \/> this motor with what type of drive?

ForUM closed to inform the respected OMRON fans, thanks to the support has been! In order to provide better service
UM will be closed (scheduled for May 29, 2015 0), there are those who need to redeem as soon as possible. Thank you for your cooperation! (note that due to historical posts will be cleared, the need

Who has proface gp3000 touch screen programming software? Ask God to contribute a. Thank you

The use of the software I have an old equipment, the use of imported C200HE, CPU-42 P
00HE, CPU-42 PLC, can use CX-one programming on it?

Who is that SGDM-01ADA Yaskawa servo controller, the motor is 100W, I want to buy a second-hand, the best, the premise is that you tell me how to answer

How do I take the maximUM value from the DM data store?
UM value in a DM965 data store on the touch screen. The value of DM965 memory is given by analog module, and the value of DM965 data memory is always changing. Please give advice to experts. It is be

E700 frequency converter communication problem
00 with FR-A7NP-E-Kit, frequency converter has been set to network operation mode. But in GX Configurator-Dp7.04, monitor the slave station status, show no connection from the station, QJ71PB92V commu

Data say, "command pulse accUMulation * electronic gear = feedback pulse accUMulation", why not actually?
UMulate 8260, the gear ratio is 65535:5000, according to the calculation of 630* (65535/5000) =8257.536. This is not consistent with the data "instruction pulse accUMulation * electronic gear = f

GP2500 SC41 24 fault (02:FF1)