FX1S-14MR-001 register for help, D8114 fault.
00, D8114, D8114 is always 0, when M8000 is turned on and M8114 is normally open. Replace other FX1S, PLC, and BD modules, as is the case. Seek expert advice. Appreciate！

Servo motor SGDV-1R6F01A, maximUM torque, continuous output, how long will alarm
UM torque (3

SGMJV08ade6s connect to drive SGDV-2R8A01A, show 100, consult an expert, thank you

FR-A700 analog reversible operation control
Question: FR-A740-15-CHT inverter, if only a running signal (STF or STR) + plus and minus 10V command voltage, the inverter can be reversed operation? Analog voltage terminals 2 and 5 have only 0~10V

Ask GP2500-TC41-24V how to calibrate the touch screen

MITSUBISHI Q series PLC and HMI-PFXGP4301TADC nUMber of connections over 16 problems
UMber of HMI connections, there is now a manual n by MITSUBISHI PLC-Q03UDECPU

200W servo motor sgmjv-02ada61 how many volts?

Fq215100 scene switch CJ1W-MD261
00 scene switching problem, Where is the setting of the IN0 IN1 corresponding, set on FQ03D, or set by PLC? Help experts answer

How does the MITSUBISHI FX3U configure 12 pulse outputs and 100 inputs and 60 output Q170MSCPU?
00 inputs and 60 outputs?. At present, there are 6 devices with similar configuration but different functions, which require 6 interactive communication data. How do you plan? And each of these 6 devi

MPT002-G4P-V1 can not communicate with CP1H
002-G4P-V1 and CP1H, MPT002-G4P-V1 and COMMUNICTION TIME showed that everything is normal, OVER CP1H serial link, MPT002-G4P-V1 indicator lights COM and CP1H flash link normal, MPT002 analog display s