FX2N-1PG setup problem

Time: 3/29/2017 1:12:20 AM

1. BFM #0 FX2N-1PG the FX2N-1PG number of sets of lap pulses! I would like to ask what is the difference between the servo drive set resolution and contact, if I want to set resolution 5000 how to operate
2. #2 is set to feed each circle! What does this have to do with BFM01?
3. What is the role of #3 in b0b1? How to determine whether the feed unit is mm or angle or inch?
If you want to set the resolution

Hello。
1, look at the servo encoder divided by the ratio of servo electronic gear is what value, this value is how much to turn around the servo pulse, set this value to FX2N-1PG BFM#0. Note that this value is determined by the servo, not by FX2N-1PG.
2, the amount of displacement of each feed is determined by the machine, the general is the lead screw by the deceleration ratio. Set this value to BFM#2#1