MITSUBISHI FR-A740-5.5K-C9 INSTRUCTION MANUAL (BASIC) PDF

Power: 37kw.
Voltage: 400V.
The surge voltage of the motor can be suppressed when the 400V motor is driven by a frequency converter.
Motor suitable for 5 FR-A740-5.5K-C9 PDF. 5 to 37kW. Display: 16 characters x 4 lines.
Can monitor, change the value of software components.
Can also be simple to operate, change the value.
Equipped with a button operation can be used (operator certification function) and control through the PLC control function,
Can be used with the function expansion board FR-A740-5.5K-C9
Can be installed directly to the FX3GA, FX3G, FX3GE, no wiring. Input points: 16 points.
Power supply: the basic unit to the expansion module to provide power FR-A740-5.5K-C9 PDF.
Terminal type: European terminal.
Weight: 0.15kg.
FX3GC, FX3UC can be directly connected to the input and output expansion equipment, to achieve a compact expansion.
Can choose 16 points, 32 points of the relay or transistor input and output models.
FX2NC-16E_-T-DS for terminal units can be disassembled models FR-A740-5.5K-C9 PDF. Max input / output points: 64 points.
Power supply voltage: 24VDC.
Input points: 32 points.
Output points: 32 points.
Output type: Transistor (sink).
Power consumption: 11W.
Weight (kg):0.35.
Size (WxHxD) mm:60x90x87.
Taking into account space saving and processing speed MITSUBISHI INSTRUCTION MANUAL.
Connector input and output type compact high performance universal machine.
Compact, scalable input / outpput FR-A740-5.5K-C9 Manual.
Can connect analog quantity, communication, positioning, etc..
Rich special extension equipment for FX2N.
By connecting the compact FX2rvc series with the input and output expansion module MITSUBISHI INSTRUCTION MANUAL.
The input and output can be extended to 256 points.
Built in 8000 step RAM memory.
By installing the memory card box, the maximum can be extended to the 16000 step.
Overseas oriented products meet all kinds of international standards.
Use terminal module to replace connector connection or relay terminal row connection,
So as to save the wiring inside the cabinet MITSUBISHI INSTRUCTION MANUAL. Power: 11kw.
Purpose: high frequency braking resistor.
The use rate of the built-in regenerative brake of the transducer can be promoted.
When using the FR-ABR type brake resistor, the short circuit piece between the terminal PR-PX is removed. Does not remove the short circuit chip will lead to overheating of the brake resistor.
The utilization rate of the regenerative braking should be less than the allowable brake use rate in the above table.
With the operating frequency of the brake resistor to reach 300 degrees C or higher, it is necessary to take protective measures and cooling FR-A740-5.5K-C9 INSTRUCTION MANUAL.
MYS type resistor can be used. But please pay attention to the allowable brake use rate.
Do not remove the terminal P/+ and P1 between thhe short circuit chip, in addition to connecting the DC reactor FR-A740-5.5K-C9 Manual.
The installation of thermal relay, to avoid overheating and burn the braking resistor.