MITSUBISHI Q25PRHCPU Programming Guide Book (Structured Text) PDF

For 32 point I/O. 0.5 square mm (AWG20).Input points: 8 points (dual input), 16 points (single input).
Isolation mode: photoelectric coupling.
Rated input voltage: DC24V Q25PRHCPU PDF.
Output points: 4 points (select the source type + drain type), 2 points (when selecting the source type + source).
Isolation mode: photoelectric coupling.
Rated input voltage: DC24V.
Security PLC (secure programmable system) refers to the self or external components or the implementation of the failure of the agency,
Can still respond to and promptly cut off the output of the programmable system Q25PRHCPU
Different from ordinary PLC, security PLC not only can provide the function of ordinary PLC,
Safe control function can be realized,
Meet the requirements of the ISO 13849-1 EN and IEC 61508 control system safety related component standards Q25PRHCPU PDF.
PLC security market mainstream has oilz (Pilz) PSS 3000, PSS 4000,
PSS 4000 in addition to the security process can also be processed outside the standard control procedures Q25PRHCPU PDF.
All the components in the security PLC adopt the redundancy structure,
Two processor processing for cross detection,
The processing results of each processor are stored in their respective memory,
Output is only when the processing result is in full agreement,
If any inconsistency occurs during the process, the system is immediately shut down MITSUBISHI Programming Guide Book. "Maximum control axis: 16 axis.
Connection mode with servo amplifier: IE CC-Link field network connection type.
The maximum distance between the drive units: 100m.
Operation cycle: 0 MITSUBISHI Programming Guide Book. 88ms, 1.77ms, 3.55ms.
Interpolation functtion: linear interpolation (maximum 4 axis), 2 axis arc interpolation Q25PRHCPU Manual .
Color signal: 4 points.
Color detecting set: 16 set.
Motion control into CC-LinkIE network.
Positioning control, synchronization control and cam control can be easily carried out by the simple parameter setting and the starting of the sequential program MITSUBISHI Programming Guide Book.
QD77GF can be used as the main station of CC-LinkIE network.
Communication between 1 network implementation and servo amplifier, field device (remote I/O, sensor, etc.).
Note 1:QD77G only the master station can use the bus shape, star. 1 networks can connect up to 104 units from the device.
Even the long distance wiring can be flexible.
The use of fiber optic cable, with high speed, high performance, high reliability of the servo system controller network.
In addition to the traditional positioning control, but also to support speed / torque control and synchronous control.
Use simple movement module setup tool",
Can easily perform positioning settings, monitoring and debugging, etc..
In addition, the data can be collected and displayed synchronouslyy with the motion controller Q25PRHCPU Programming Guide Book.
Support comprehensive, wiring flexible IE CC-Link field network.
This module can be used as the main station of IE CC-Link field network (equivalent to QJ71GF11-T2),
And still retains the function of ssimple motion module Q25PRHCPU Manual .
Therefore, flexible connection display (GOT), remote I/O, frequency converter and other equipment, flexible construction system. "