MITSUBISHI GT11H-50ESCOV datasheet PDF

For external input / output devices and operation panel (negative public transport / source output).
Applicable models: GT16, GT15, GT27, GT25. Support for 5.7 inch.
Applicable models: GT16, GT15. Used to simulate the RGB output.
Applicable model: GT15. Cable length: 10 meters.
QnACPU GOT.
RS-422 conversion (FA-CNV / CBL) cable GOT GT11H-50ESCOV PDF.
The serial communication module GOT.
The peripheral machine connection module (AJ65BT-G4-S3) GOT GT11H-50ESCOV
[D-sub 25 pin loose line (row 5 pin interface terminal)].
GT2103-PMBD does not support Q00JCPU, Q00CPU, CPU Q01CPU direct connection.
Applicable model: GT21. A series of high performance models that are widely used in network or single machine work environments.
Screen size: 12 GT11H-50ESCOV PDF. 1 inches.
Display color: 256 color or more color.
Installation type: compatible with video /RGB.
Resolution: SVGA (800 x 600).
Display device: TFT color (high brightness, wide viewing angle).
Host frame color: black.
Power type: AC100~240V.
Communication interface: with built-in RS-422.
Ideal model for high performance in a network or independent operation environment.
User storage capacity: 9MB (GT15__-VNB_:5MB) GT11H-50ESCOV PDF.
Device USB port.
Standard RS-232 interface.
Support video /RGB unit.
If the capacitive touch screen is in the middle of the operation, the display resolution or display mode of the touch screen is changed again,
Or the refresh rate of the touch screen controller is adjusted by itself, and the cursor and the touch point can not be felt when the cursor is not corresponding to the touch point,
Must be re calibrated to the touch screen system.
In order to ensure the normal operation of the touch screen system, in addition to ensure the proper installation of the system software,
Must also remember that in a host do not install two or more than two kindds of touch screen driver,
This will cause the system to run in conflict, so that the touch screen system can not be used properly GT11H-50ESCOV datasheet. Cable length: 20m.
The connection between the FXCPU (MINI-DIN8 pin connector) and the graphicc operation terminal GT11H-50ESCOV datasheet.
Connection between FXCPU communication function extension board (MINI-DIN8 pin connector) and GOT.
Applicable models: GT10, GT21.