MITSUBISHI HG-SR5024B

USB interface protection cover on the front panel of the host computer (for replacement).
For 15 inches /12.1 inches /10.4 inches /8.4 inches.
Applicable model: GT15. Peripheral equipment A/QnA series CPU unit connection cable.MITSUBISHI inverter series: FR-F840.
Voltage level: three phase 400V.
Power: 18 . 5kw.
SLD converter rated current: 38 HG-SR5024B. 0A.
Structure and function: Standard model.
Type: CA.
Substrate coating: have HG-SR5024B
2 times the power consumption of the wind turbine and pump and the speed of the 3 power consumption is proportional to the speed of the rotating speed.
Through the speed control of the frequency converter to adjust the air flow, can reduce the power consumption HG-SR5024B.
Give full play to the performance of the motor .
The excitation current is always adjusted to the best state, which can improve the efficiency of the motor.
Load torque is smaller, can further improve energy efficiency.
For example, when a general motor is used, the optimal excitation control mode in the 4% motor load torque is about 30% more than that of the V/F control. Support for 5 HG-SR5024B. 7 inch.
Applicable models: GT16, GT15 . Series: multimedia and advanced features and features of a variety of high-performance models.
Screen size: 15 inches.
Display color: 256 color or more color.
Installation type: compatible with multimedia and video /RGB.
Resolution: XGA (1024 x 768).
Display device: TFT color (high brightness, wide viewing angle).
Host frame color: black.
Power type: AC100~240V.
Communication interface: with built-in RS-422.
High performance models with multimedia and advanced features and functionality (including embedded communications capabilities).
User storage capacity: 15MB (GT16__-VNB__:11MB).
With HOST USB and device USB port.
Standard Ethernet, RS-422/485 and RS-232 ports.
Support multimedia and video /RGB units.
Analog touch panel.
Do not let the touch screen surface with water drops or other soft things stick to the surface,
Otherwise, the touch screen is easy to mistake that there is a hand touch caused by surface acoustic wave screen is not allowed.
In addition to cleaning the dirt on the surface of the touch screen,
You can use a soft dry cloth or a cleaning agent to clean out the center of the screen carefully,
Or use a dry soft cloth dipped in industrial alcohol or glass cleaning fluid to clean the touch screen surface.
Touch screen response is slow if you use a hand or other touch to touch the surface acoustic wave touch screen,
This shows that it is likely that the touch screen system has been obsolete, the internal clock frequency is too low,
Or because there is water in the surface of the touch screen to make the touch screen mobile, rapid response recovery,
TTo replace or upgrade the system must, or use dry cloth touch screen on the surface of the water HG-SR5024B.
If the user is operating the touch screen, the direction of the touch move is to the left,
But the cursor of the system moves to the right,
The failure may be due to the conneecttion of the control box and the touch screen connected to the connector or the touch screen,
Users as long as the direction of the re exchange of it HG-SR5024B.
HG-SR5024B Operation manual / Instructions / Catalog download link: /searchDownload.html?Search=HG-SR5024B&select=5