MITSUBISHI HC-UF23

Fiber length: 20 meters.
SSCNET III cables (external standard optical fiber control cabinet).
Joints for CN1A and CN1B. Motor series: medium inertia, medium capacity.
Using a serial absolute / incremental encoder.
Rated output power: 7.0kw.
Rated speed: 2000rpm.
With the brake: without.
Shaft end: straight shaft .
The rotor of AC servo motor is usually made of squirrel cage, but in order to make the servo motor has a wide range of speed regulation, linear mechanical properties,
Without the "rotation" phenomenon and the performance of the fast response, it is compared with the ordinary motor,
The two characteristics of rotor resistance and moment of inertia should be provided HC-UF23
At present, there are two kinds of rotor structure, one is the squirrel cage rotor, which is made of conductive material with high resistivity,
In order to reduce the moment of inertia of the rotor, the rotor is slender HC-UF23. MITSUBISHI inverter series: FR-F820.
Voltage level: three phase 200V.
Power: 3.7kw.
SLD converter rated current: 25A.
Structure and function: Standard model.
Type: CA HC-UF23.
Substrate coating: have.
Compatibility with existing models .
Transducer installation size and FR-F700 (P) series of the same, so you do not need to worry about the replacement operation.
(rectifier separation type will vary)
Also, but also through the use of options (FR-A8TAT), FR-F700 (P) series installed control loop terminal station.
Built in 2 PID arithmetic. In the inverter can be PID control of the motor state at the same time, used in the control of the external machine.
No external PID controller is used to control the external machine, so the system cost can be reduced. MITSUBISHI inverter series: FR-F840.
Voltage level: three phase 400V.
Power: 3.7kw.
SLD converter rated current: 8.3A.
Structure and function: Standard model.
Type: CA.
Substrate coating: have.
2 times the power consumption of the wind turbine and pump and the speed of the 3 power consumption is proportional to the speed of the rotating speed.
Through the speed control of the frequency converter to adjjust the air flow, can reducee the power consumption HC-UF23.
Give full play to the performance of the motor.
The excitation current is always adjusted to the best state, which can improve the efficiency of the motor.
Load torque is smaller, can further improve energy efficiency.
For exxample, when a general motor is used, the optimal excitation control mode in the 4% motor load torque is about 30% more than that of the V/F control HC-UF23.
HC-UF23 Operation manual / Instructions / Catalog download link: /searchDownload.html?Search=HC-UF23&select=5