MITSUBISHI Q170DEMICBL3M

Cable length: 2m.
RS-485 terminal unit conversion unit.
Applicable model: GT16. Type: HA-SE series.
Rated output: 1.2KW.
Rated speed: 1000r/min.
Electromagnetic brake: there.
Control complex, easy to achieve intelligent,
The electronic commutation method is flexible and can be changed by square wave or sine wave .
Motor maintenance free, high efficiency, low operating temperature,
Electromagnetic radiation is very small, long life, can be used in a variety of environments Q170DEMICBL3M
AC servo motor is brushless motor, which is divided into synchronous and asynchronous motor,
Synchronous machines are commonly used in motion control,
Its power range, you can do a lot of power Q170DEMICBL3M.
Large inertia, the maximum rotation speed is low, and with the increase of power and rapid reduction .
So it is suitable for the application of low speed and stable operation.
The rotor of the servo motor is permanent magnet,
Drive controlled U/V/W three phase electric electromagnetic field,
The rotor rotates under the action of the magnetic field,
At the same time the motor comes with the encoder feedback signal to the drive,
According to the feedback value and the target value, the driver is compared,
Adjust the rotor rotation angle Q170DEMICBL3M.
The accuracy of the servo motor is determined by the accuracy of the encoder. The length of the line: 10M.
IP level: IP65.
Direct type.
The cable is not shielded.
Bending life: standard.
Connector kit for motor electromagnetic brake.
Cable for electromagnetic brake, for HF-KP/HF-MP series (motor shaft with side extraction). A6WU-A6PHP/A6HGP connection cable.
Length: 0.3m. Output type: transistor output, source.
Output points: 16 points.
OFF leakage current: 0.30mA.
Output protection function.
Rated load voltage / current: DC12V/DC24V/0.1A.
External connection: 2 wire.
Waterproof connector type.
Strong waterproof type of IP67 protection grade.
No need to stop the system can be replaced module.
Without the use of tools can be a simple connection, save time.
Terminal resistor built-in.
Can be installed along the 6 direction.
Hardware simulation method is to use a number of hardware equipment to simulate the generation of the signal,
The signals are connected to the input end of the PLC system in a haard wired way, and the timeliness is strong Q170DEMICBL3M.
Software simulation method is in the MITSUBISHI PLC in the preparation of a set of simulation program,
The simulation provides the field signal, which is simple and easy to operate, but it is not easy too gguarantee the timeliness Q170DEMICBL3M.
Simulation of the process of debugging, debugging method can be used to segment, and the monitoring function of programmer.
Q170DEMICBL3M Operation manual / Instructions / Catalog download link: /searchDownload.html?Search=Q170DEMICBL3M&select=5