How many X1S FX1S-14MR-001 and FX1S-14MR-001 FX1N-1DA-BD have you bought?. When writing a program, it is found that D8114 cannot give constants.
If program MOV, K100, D8114, D8114 is always 0, when M8000 is turned on and M8114 is normally open.
Replace other FX1S, PLC, and BD modules, as is the case.
Seek expert advice. Appreciate!
Re: Time: 9/21/2017 1:53:00 AM
Check to see if PLC is running (RUN is lit). If you are already in the running, you can not determine the cause for the moment, it is recommended to call 400-- free technical hotline for further communication.
Re:Re: Time: 9/21/2017 4:17:00 AM
In addition, check to see if the FX1S hardware version is more than 2: monitor the D8001, and the 3 digit is greater than 200.
Re:Re:Re: Time: 9/21/2017 9:05:00 AM
The D8001 version is 22210
Re:Re:Re:Re: Time: 9/21/2017 11:29:00 AM
The D8001 value is 22210, the version is 2.10, the version is more than 2, and the version meets the requirement.