LK166
Home >> Problems >> The problem of editing a ladder diagram Q13UDVCPU
Problem sort

The problem of editing a ladder diagram Q13UDVCPU

Time: 8/1/2017 8:22:25 PM

RT, new f Q13UDVCPU edit Q13UDVCPU ladder diagrams, download to PLC, debug, monitor, etc., at first, no problem, but after several downloads or surveillance, online editing or offline editing, there are the following problems.
1: change an instruction or change the D data, etc., not directly change, so that the instructions to change next to an instruction.
2: delete instructions or connections, sometimes deleted. With shear, you can.
3: insert "or" instruction
Re:   Time: 8/2/2017 1:53:00 AM
1,2: you may change the edit mode to insert mode, insert mode and overwrite mode switch, simply operate the keyboard "Insert insert" key.
The 3:OR and ORI instructions are used as a parallel connection of 1 contacts.
When more than 2 contacts are connected in series, the ORB command is used when the series loop block is connected in parallel with the other loop.
Thank you for your automation of MITSUBISHI motors
Re:Re:   Time: 8/2/2017 4:17:00 AM
Thanks, problem solving
Re:Re:Re:   Time: 8/2/2017 9:05:00 AM
You are welcome. I am glad to be able to handle your queries. You are welcome to leave a message again or call our technical support hotline 400--.
Related problems
Related products
MITSUBISHI
General high speed CPU
Q13UDVCPU
MITSUBISHI General high speed CPU Q13UDVCPU
Input / output points: 4096 points. Input / o
Related download