LK166
Home >> Products >> MITSUBISHI >> Servo driver/Servo motor >> MR-J3 series >> MR-J3 amplifier >> MR-J3-22KB-RJ080W MITSUBISHI For direct drive servo motor drive

MR-J3-22KB-RJ080W MITSUBISHI For direct drive servo motor drive

Brand: MITSUBISHI
Name: For direct drive servo motor drive
Model: MR-J3-22KB-RJ080W
MITSUBISHI motor universal AC servo amplifier MELSERVO-J3 series.
Rated output: 22.0kw.
Interface type: SSCNET type III fiber communication.
Special specification: suitable for direct drive servo motor.
Power specification: three phase AC200V.
Direct drive system suitable for high speed and high precision!
High speed operation can be realized by direct drive (2m/s), and the traditional mechanical transmission can not achieve such a high speed.
The full closed loop control can be realized by using the position feedback signal from the load side encoder, such as the linear encoder.
The use of a flexible linear servo motor drive components can make the system more compact structure.
The primary side of the linear servo motor (motor coil) is sliding along the secondary side (permanent magnet) of the motor,
So linear servo motor is especially suitable for large range of applications. In addition, linear servo motor can be connected in series,
Especially for large systems in two axes for high precision synchronous operation.

MITSUBISHI motor universal AC servo amplifier MELSERVO-J3 series.
Rated output: 0.4kw.
Interface type: CC-Link communication type (built-in positioning function).
Power specification: single phase AC200V.
Positioning operation by setting position and rotational speed data in the positioning table and receiving the start signal from the main controller MR-J3-22KB-RJ080W MITSUBISHI.
The setting of the position and speed of the positioning table, as well as the start and stop operation can be completed through CC-Link communication MR-J3-22KB-RJ080W
By using the MR-J3-D01 extension IO unit, the DI/O instruction can be used to select and locate the table.
(CC-Link can not be used for MR-J3-D01 communications).
With built-in positioning function of the servo amplifier, can be set through the CC-Link communications and speed data MR-J3-22KB-RJ080W MITSUBISHI. (corresponding to the CC-Link version: Ver.1.10)
Can be achieved through the CC-Link communications to start, stop and monitoring and other operations.
Serial communication reduce wiring.
Distributed servo control system can be built by CC-Link communication.
The parameters of unit MR-PRU03 (optional) the parameter setting, operation and monitoring more convenient MR-J3-22KB-RJ080W MITSUBISHI.
The servo amplifier can be used for speed control operation.
When the two stations are occupied, the speed can be set directly by the remote register. Type: MR-C type.
Symbol 10A for motor models: HC-PQ23.
Power supply voltage: single phase AC100V.
Drive: servo drive in the development of the premise of the frequency conversion technology,
Current loop in the drive,
Speed loop and position loop (frequency converter without the ring) have carried out a more precise control than the general frequency control technology and algorithm,
In ffunction is also a lot stronger than the traditional servo,
The main point can be precise position control MR-J3-22KB-RJ080W.
The control speed and position are controlled by the pulse sequence transmitted by the upper controller,
The internal algorrithm of the driver and the faster and more accurate calculation and better performance of electronic devices to make it more superior to the inverter MR-J3-22KB-RJ080W.


...More relevant models >>>>