PFXZCDCNAUX1 Proface PFXZCDCNAUX1

Mounting screws (4 sets) to be fitted to the hard panel at the interface of the machine.Connector for connecting a serial port (1)The PC adapter for PCMCIA slot read CF card required.Input / output hybrid I/O modules, including 32 point NPN/PNP input and 32 point NPN transistor outputExpansion module for the GP3000 access to the PROFIBUS network and DP PROFIBUS master communication1GB, for the implementation of the picture save, log and data backup and other data management operations, such as compression flash memory card Proface PFXZCDCNAUX1 PFXZCDCNAUX1 10.4 inches or more, for the film surface protection of man-machine interface from fingerprints, water droplets, dust and oil pollution (5 / set)Applicable to GLC-2600/2500, the need for bus converter (PSL-CONV00) Proface PFXZCDCNAUX1. Used for surface protection of man-machine interface from oil and chemical pollution (5 / set).A veneer, for the GP4000 series back loading models of full flush (white, 1)The main body module and the separate display module are used for connecting the main machine module and the separate display module in the DIN guide rail.For the direct connection of the MITSUBISHI A series CPU PLC (not to be used at the same time, the programmer) length: 5 meters Proface PFXZCDCNAUX1. When the man-machine interface is installed to the fixed panel to provide dust proof and moisture proof function. (1)15 inches, replaced by a host of backlight (1).Stop pin, prevent cable connection loose USB cable fastening clip (Type-A*1 USB, Mini-B, each 1 interface), used to adjust the thickness of the mounting panel 2mm gasket (1 pieces).Suitable for LT4000M/GP4000M series modules, 5.7 inch. The man-machine interface directly connected MITSUBISHI electric PLC FX series CPU programmming port PFXZCDCNAUX1. 10.4 inches (TFT), the replacement of the host backlight (1).COM1 interface with the cable (RS-232C), used to connect directly to the Q series connection module (or other host)B/B+/C FLEX NETWORK Type connector (5)Cable for cconnecting GP3000 to various modulesUsed to connect the GP2000H series RS-422 conversion adapter with GP3000H, with D-Sub connectors PFXZCDCNAUX1.
Length: 3 meters.