MITSUBISHI FX2N-GM-5EC datasheet PDF

Total points: 10 points.
Input points: 6 points.
Output points: 4 points.
Voltage: AC220V.
Output type: relay.
Outline dimension: 60*75*90.
MITSUBISHI FX1S series PLC is suitable for the smallest package,
It is the preferred target for low cost users to seek powerful control over a limited range of I/0 FX2N-GM-5EC PDF.
FX1S provides up to 30 I/O points, and can be transmitted through serial communication data,
MT models also have the ability to locate, widely used in a variety of small mechanical equipment FX2N-GM-5ECMITSUBISHI inverter FR-D740 series.
Voltage level: three phase 400V.
Frequency converter capacity: 0.75KW.
The internal and back of the inverter structure considering the cooling effect, the relationship between the upper and lower ventilation is also important,
Therefore, in order for the type of unit, hanging on the wall to the vertical position, the installation of vertical as possible FX2N-GM-5EC PDF.
Transducer can be used to drive a single phase motor? Can single phase power supply be used?
Basically can not be used. For a single phase motor with governor switch, the auxiliary winding will be burnt when the speed is below the operating point;
For the capacitor start or capacitor operation mode, the capacitor explosion will be induced FX2N-GM-5EC PDF.
The inverter power supply is usually 3, but the capacity for small, single-phase power is also useful functioning aircraft. The connector is converted to a screw relay terminal.Protocol: SLMP, TCP/IP, UDP.
Communication mode: full duplex / half duplex.
At the same time can open a few: 4 connection.
Weight: 0.3kg.
Connect PLC FX3U/FX3UC to Ethernet.
Support fixed buffer storage, communication connnection MELSOFT, through the MC communication protocol, e-mail messages FX2N-GM-5EC datasheet.
When connected to the MELSOFT, through the Works2 PLC can achieve the remote maintenance of GX program.
Connecting FX3UC, FX3GC requires FX2NC-CNV-IF or FFX3UC-IPS-5V FX2N-GM-5EC datasheet. Uses: for external BCD or binary digital signal to do the frequency of a given.
Applicable frequency converter: FR-A700, FR-F700, FR-E700"